New Pudding boat being built in France.

[darebarry]

Jean- Yves is about to be building a pudding boat in France, he has the plans and is working on them at present. he needs help with a few measurements that I do not have. I have suggested he puts his questions for you to answer. 

[David Wilkins]

Great news Dare - I guess this one will be a dessert rather than a pudding!

[3513SL]

I am hoping that Jean-Yves posts here, but a preview of his plans are attached.

[Geypee]

Hello Dare,

I am here now, but still a beginner, as N12 designer and forum member. Worst of all, I am French!

I would like to get the following measurements (see drawing attached) in order to put shroud plates reinforcements. An average value would be greatly appreciated. Thanks for your help and support.

[Sam White]

Looks a sexy little design there.
I only have older n12's, one from 1975 and one from 1988 but happy to send you the spreader and shroud measurements next time I get down to the club

[David Sanderson]

From the tuning guide a length of 330mm and a depth of 130mm would be a place to start.
What is "correct" somewhat depends on the mast I believe

Dave

[Geypee]

Thanks Dave, will use those measurements as a start for my design project.